Zenith Data Systems MT2000 - Manual (Page 122)

5-34
Upgrades and Options
Power Supply Module
The following sections provide procedures for removing
and installing a power supply module.
Removing a Power Supply Module
If the amber LED on a power supply module is lite, the
power supply module can be hot swapped. If the amber
LED on a power supply module is not lite, it is
recommended that power to the system be turned off,
before removing the power supply module.
To remove a power supply module, perform the
following steps (see Figure 5-13).
1. Press the locking clip on the release-handle with
your thumb.
2. Pull the release-handle with your index fingers.
3. Remove the power supply module.