Zenith Data Systems MT2000 - Manual (Page 68)

4-15
Configuring Your System
Table 4-5. BIOS Setup Configurations (Continued)
MENU PARAMETER NAME NORMAL SETTING
OR DISPLAY ONLY
YOUR
CONFIGURATION
MAIN MENU
Memory Shadow
Press ENTER for menu.
System Shadow Enabled
Video Shadow Enabled
*Regions with Legacy Expansion ROMs
*Boot Sequence
Press ENTER for menu.
Boot Sequence A: then C:
SETUP Prompt Enabled
POST Errors Enabled
Floppy Check Enabled
*Numlock
Press ENTER for menu.
Numlock ON
Key Click Disabled
Key Board auto-repeat rate 30/sec
Key Board auto-repeat delay ½ sec
Base Memory: 640 KB
Extended Memory: Display only
ADVANCED MENU
*Integrated Peripherals
Press ENTER for menu.
Serial Port 1 3F8, IRQ 4
Serial Port 2 2F8, IRQ 3
Parallel Port 378, IRQ 7
Parallel Mode Bi-directional
Diskette Controller Enabled
Mouse Enabled
* This parameter will be overwritten by the SCU setting.