Zenith Data Systems MT2000 - Manual (Page 126)

5-38
Upgrades and Options
Figure 5-14. Disk Drive in Hot-swap Bay
4. Open the EMI metal panel by turning its two thumb
lock screws counter clockwise.
5. Grasp the handle of the hard disk’s carrier and press
down on its thumb-release button (see Figure 5-14).
6. If you are removing a faulty drive, check all the
drive LEDs to confirm which drive to remove. Refer
to “Status LED Indicator Descriptions” in Chapter 2.
Notice: Depending on the drive fault, the drive may be
still spinning when you remove it. Follow the next step
exactly when removing drives.