Zenith Data Systems MT2000 - Manual (Page 162)

6-19
Problem Solving
Table 6-2. BIOS Messages (Continued)
MESSAGE DESCRIPTION
Press <F1> to resume, <F2> to Setup Displayed after any recoverable error message.
Press <F2> to enter SETUP Optional message displayed during POST. Can be turned off
in Setup.
Previous boot incomplete - Default
configuration used Previous POST did not successfully complete. POST loads
default values and offers to run Setup. If the failure was
caused by incorrect values and they are not corrected, the
next boot will likely fail. On systems with control of wait
states, improper Setup settings can also terminate POST
and cause this error on the next boot. Run Setup and verify
that the wait-state configuration is correct. This error is
cleared the next time the system is booted.
Real time clock error* Real time clock fails BIOS test. May require board repair.
Shadow Ram Failed at offset: nnnn* Shadow RAM failed at offset nnnn of the 64K block at which
the error was detected.
nnnn Shadow RAM Passed Where nnnn is the amount of shadow RAM in kilobytes
successfully tested.
System battery is dead - Replace and
run SETUP The CMOS clock battery indicator shows the battery is dead.
Replace the battery and run Setup to reconfigure the
system.
System BIOS shadowed The system BIOS is copied to shadow RAM.
System cache error - Cache disabled* The RAM cache failed the BIOS test and BIOS has disabled
the cache.
System CMOS checksum bad - run
SETUP The system CMOS has been corrupted or incorrectly
modified, perhaps by an application program that changes
data stored in CMOS. Run Setup and reconfigure the
system either by getting the default values or making your
own selections.
System RAM failed at offset: nnnn* The system RAM failed at offset nnnn of the 64K block at
which the error was detected.
nnnn System RAM Passed Where nnnn is the amount of system RAM in kilobytes
successfully tested.
System timer error* The timer test failed. Requires repair of the system board.
UMB upper limit segment address:
nnnn Displays the address nnnn of the upper limit of the Upper
Memory Blocks, indicating released segments of the BIOS
which may be reclaimed by a virtual memory manager.
Video BIOS shadowed The video BIOS is successfully copied to shadow RAM.
* If your system displays this message, write down the message and notify your customer
representative. If your system fails after you made changes in the BIOS Setup menus,
you may be able to correct the problem by entering Setup and restoring the original
values.