Zenith Data Systems MT2000 User Manual
Page 133
5-45
Upgrades and Options
Figure 5-19. Removing Side Rails
C
A
B
Removing side rails from
blank panel tray
A Screws
B Side rails
C Blank panel tray
11.
Remove the device from its protective wrapper and
place it on an antistatic surface. Record the drive
model and serial number in the equipment log.
12.
Set any device jumpers or switches on the device.
Refer to the installation procedures that came with
the device.
Notice: SCSI termination resistors for the 5 1/4-inch
devices must be installed in the last SCSI device of the
daisy chain cabling (top media bay A). All other 5 1/4-
inch devices must have terminators removed.
13.
Using the four screws supplied with the drive,
reinstall the side rails just removed from the blank
panel tray (Figure 5-20, A). Attach the rails to each
side of the device (C) by using only the bottom screw
holes, as shown. The rails for each side of the device
are identical.