Zenith Data Systems MT2000 - Manual (Page 71)

4-18
Configuring Your System
Exiting BIOS Setup
To exit Setup, select Exit from the menu bar to display
the Exit Setup menu.
The following table describes the options on this menu.
Note that ESC does not exit this menu. You must select
one of the items from the menu or menu bar to exit this
menu.
SELECTION DESCRIPTION
Save changes and
Exit Stores the selections displayed in the menus in
CMOS and exits the Setup program.
Exit without Saving
Changes Exits the program without saving any changes you
have made in this session. Previous selections
remain in effect.
Get Default Values Displays default values for all Setup menus. Useful
if BIOS detects a problem with the values stored in
CMOS.
Load Previous
Values Reverts to previously saved values if the new
values have not been saved to CMOS.
Save Changes Stores the current selections without exiting the
Setup program.
Using the Utilities Diskette
The utilities diskette included with your system
contains the SCSISelect Utility and an Event Log
Reader Utility.
Note: Because of license restrictions, the Utilities
diskette, as supplied, is not bootable. In order to use
this diskette, you must make it bootable and copy
CHOICE.COM from the MS-DOS directory on your hard
drive to the diskette.
To run the Utilities diskette, perform the following
procedure:
Note: Perform Steps 2 and 3 of this procedure the first
time you use the utilities diskette. These steps enable
the diskette to be MS-DOS bootable.
1. Power-on the system. The system boots up.