AASTRA Office 35IP User manual - Manual (Page 43)

Using Added Features to Make Efficient Phone Calls
43
Switching active lines
You are in a call and want to answer a call on another Line key or make a call.
You can switch lines by pressing a single key. The caller is automatically parked locally and later
reactivated by pressing the corresponding Line key.
Activating / Deactivating Functions by Remote Control
You are not at your desk and want to set various functions on your phone from a different phone.
You can activate / deactivate many of your phone's functions by remote control from a different phone.
Remote control has to be enabled for your phone in the system.
Remote control is possible from within and from outside the system. For external remote control,
the system administrator has to give you the dial-in number.
The remote control is initiated using a special */# procedure. You can then enter the function commands
and */# procedures in the usual way.
Press the Line key you want.
The call partner is now parked. The selected line is activated.
To retrieve a parked call party: Press the relevant Line key.
You are now through to the parked call partner again.
Note To retrieve a parked call party: Press the relevant Line key.
However: You cannot use this method to take calls on busy lines.
To remote control from a third-party phone: Pick up the handset.
To initiate remote control:
Enter */# procedure *06.
Enter your phone number.
Enter the */# procedure for activating / deactivating the function you want.
Put the handset on-hook.
☛
☛