Restrictions in atmega103 compatibility mode, Overview, Atmega128(l) – Rainbow Electronics ATmega128L User Manual

Page 106

Advertising
background image

106

ATmega128(L)

2467B–09/01

16-bit Timer/Counter
(Timer/Counter1 and
Timer/Counter3)

The 16-bit Timer/Counter unit allows accurate program execution timing (event man-
agement), wave generation, and signal timing measurement. The main features are:
•

True 16-bit Design (i.e. Allows 16-bit PWM)

•

Three Independent Output Compare Units

•

Double Buffered Output Compare Registers

•

One Input Capture Unit

•

Input Capture Noise Canceler

•

Clear Timer on Compare Match (Auto Reload)

•

Glitch-free, Phase Correct Pulse width Modulator (PWM)

•

Variable PWM Period

•

Frequency Generator

•

External Event Counter

•

Ten Independent Interrupt Sources (TOV1, OCF1A, OCF1B, OCF1C, ICF1, TOV3, OCF3A,
OCF3B, OCF3C, and ICF3)

Restrictions in ATmega103
Compatibility Mode

Note that in ATmega103 compatibility mode, only one 16-bit Timer/Counter is available
(Timer/Counter1). Also note that in ATmega103 compatibility mode, the Timer/Counter1
has two compare registers (Compare A and Compare B) only.

Overview

Most register and bit references in this document are written in general form. A lower
case “n” replaces the Timer/Counter number, and a lower case “x” replaces the output
compare unit channel. However, when using the register or bit defines in a program, the
precise form must be used i.e. TCNT1 for accessing Timer/Counter1 counter value and
so on. The physical I/O register and bit locations for ATmega128 are listed in the

“16-bit

Timer/Counter Register Description” on page 127.

A simplified block diagram of the 16-bit Timer/Counter is shown in

Figure 45. CPU

accessible I/O registers, including I/O bits and I/O pins, are shown in bold.

Advertising