Eeprom data memory, Eeprom read/write access, Eeprom address register – eearh and eearl – Rainbow Electronics ATmega128L User Manual

Page 19: Atmega128(l), Figure 10. on-chip data sram access cycles

Advertising
background image

19

ATmega128(L)

2467B–09/01

Figure 10. On-chip Data SRAM Access Cycles

EEPROM Data Memory

The ATmega128 contains 4K bytes of data EEPROM memory. It is organized as a sep-
arate data space, in which single bytes can be read and written. The EEPROM has an
endurance of at least 100,000 write/erase cycles. The access between the EEPROM
and the CPU is described in the following, specifying the EEPROM Address Registers,
the EEPROM Data Register, and the EEPROM Control Register.

For a detailed description of SPI and JTAG data downloading to the EEPROM, see
page 292 and page 297 respectively.

EEPROM Read/Write Access

The EEPROM access registers are accessible in the I/O space.

The write access time for the EEPROM is given in

Table 2. A self-timing function, how-

ever, lets the user software detect when the next byte can be written. If the user code
contains instructions that write the EEPROM, some precautions must be taken. In
heavily filtered power supplies, V

CC

is likely to rise or fall slowly on power-up/down. This

causes the device for some period of time to run at a voltage lower than specified as
minimum for the clock frequency used.

See “Preventing EEPROM Corruption” on page

23. for details on how to avoid problems in these situations.

In order to prevent unintentional EEPROM writes, a specific write procedure must be fol-
lowed. Refer to the description of the EEPROM Control Register for details on this.

When the EEPROM is read, the CPU is halted for four clock cycles before the next
instruction is executed. When the EEPROM is written, the CPU is halted for two clock
cycles before the next instruction is executed.

EEPROM Address Register –
EEARH and EEARL

• Bits 15..12 - Res: Reserved Bits

These are reserved bits and will always read as zero. When writing to this address loca-
tion, write these bits to zero for compatibility with future devices.

clk

WR

RD

Data

Data

Address

Address valid

T1

T2

T3

Compute Address

Read

Write

CPU

Memory access instruction

Next instruction

Bit

15

14

13

12

11

10

9

8

EEAR11

EEAR10

EEAR9

EEAR8

EEARH

EEAR7

EEAR6

EEAR5

EEAR4

EEAR3

EEAR2

EEAR1

EEAR0

EEARL

7

6

5

4

3

2

1

0

Read/Write

R

R

R

R

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

R/W

Initial value

0

0

0

0

X

X

X

X

X

X

X

X

X

X

X

X

Advertising