Xylem Motor pump control unit GEN Series - Manual (Page 41)

41
FUNCTION
SELECTABLE
FIELDS
DEFAULT
SETTINGS
NOTES
“Activation of
commissioning
program”
Activation of
commissioning
program
000/001 000
000 = Disabled
001 = Enabled
FUNDAMENTAL SETTINGS
PROGRAMMING CAN BE PERFORMED ONLY WITH THE ENGINE OFF AND THE “KEY-
OPERATED SELECTOR SWITCH IN THE MAN POSITION!”
IMPORTANT: The parameters “Panel Vdc voltage” and “Crown gear teeth”, are
set by the motor pump manufacturer and MUST NOT BE MODIFIED for any
reason!
Incorrect programming of the control unit can completely change the
operation of the machine and cause, in some cases, serious damage!
Set the selector switch to the “MAN” position.
Power the electric panel, then press and hold down the PROG / RESET / ENTER pushbutton
for longer than 5 seconds, you will access the PASSWORD parameter and the cursor will start
blinking.
Enter password PW3 and confirm by pressing the PROG/RESET/ENTER key.
Select the function using the UP / DOWN buttons and confirm by pressing the
PROG/RESET/ENTER key.
Enter the parameter value using the UP / DOWN buttons and confirm by pressing the
PROG/RESET/ENTER key.
Repeat the steps above for each function you wish to set.