YSI MultiLab 4010P-1 - Manual (Page 63)

MultiLab 4010-1 Settings
ba76141e03 03/2014 63
9.2 ORP measurement settings
9.2.1 Settings for ORP measurements
The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <MENU/ENTER> key. After completing
the settings, switch to the measured value display with <M>.
Default settings are printed in bold.
9.3 D.O. measurement settings
9.3.1 Settings for D.O. sensors
(menu for measurement and calibration settings)
Settings The settings are available in the menu for measurement and calibration set-
tings. To open the settings, display the required measured parameter in the
measured value display and press the <MENU/ENTER> key. After completing
the settings, switch to the measured value display with <M>.
Default settings are printed in bold.
3. Confirm the setting with <MENU/ENTER>.
4. Quit the menu with <M>.
Menu item Possible setting Description
mV resolution 0.1
1 Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
9.6.1 R
ESETTING THE MEASURE -
MENT SETTINGS , page 70).
Menu item Possible
setting Description
Calibration /Cali-
bration record - Displays the calibration record of the
last calibration.
Calibration / Cali-
bration data stor-
age / Display - Displays the last calibration records
(max. 10)
Calibration /
Calibration data
storage / Output
to RS232/USB - Outputs the calibration data storage to
the interface