MoTeC ACL VIM - Manual (Page 14)

10 Operation
Communications Cable
ACL Manager communicates with the ACL via an Ethernet cable. Refer to the
PC Communications section for setup details.
Firmware Updating
ACL Manager is used to update the firmware in the ACL, VIMs and display
devices.
The firmware is field updatable so that new features can be used as they
become available.
i2 Pro Data Analysis
i2 Pro data analysis software is used to analyse the logged data that has
been recorded by the ACL.
For more detail please refer to the i2 Pro help.
Telemetry Monitor
The Telemetry Monitor software is used to monitor the optional telemetry link
and allows viewing of the telemetry data in various graphical formats such as
Charts, Bar Graphs and Dial Gauges. It can also show the vehicles current
track position on a track map and compare the current vehicle data to
reference data.
Alarms can be set to indicate when a particular value, such as Engine
Temperature exceeds a user programmable limit.
Display
A display device can be connected to the ACL which allows display of any
measured or calculated value. The display can also show alarm messages.
Configuration, upgrading and testing of the display device must be done using
the ACL Manager software. Do not use the configuration software that is
normally used with the display device.
Note An SDL will have access to all of the display features normally reserved
for use only with an ADL2. For example, all 3 display modes will be available.
The following description applies to the ADL2 & SDL displays.