MoTeC ACL VIM - Manual (Page 45)

MoTeC Installation & Configuration 41
Refer to Appendix K: CAN Bus Wiring for details.
ECU Setup
Use the separate ECU manager software to setup the ECU.
Select a CAN Data Set that is supported by the ACL (normally set 1).
The CAN Address must also be entered. Normal value for ACL is 1520.
This is a decimal value that corresponds to a hexadecimal value of
0x5F0 in the ACL.
ACL Setup
Using ACL Manager, select Inputs | Communications to assign the
desired ECU template to one of the CAN sections.
Select the ECU template that matches the ECU type and ECU
telemetry set.
In the displayed channel list, tick the channels that are to be received in
the ACL.
If not using CAN bus 0, click on the Advanced button to select the
correct CAN bus.
Note If metric calibration is not used in the ECU, special scaling is
required in the ACL communications setup.