MoTeC ACL VIM - Manual (Page 41)

MoTeC Installation & Configuration 37
ACL Setup
Outputs Setup
Using ACL Manager, select Functions | Shift Light Module to configure
the SLM.
Note The CAN bus number is also selected in the Shift Light Module
Setup screen.
Communications Setup
There is no need to configure the communications section of the ACL,
this is done automatically if the SLM is configured.
E888 / E816 Expanders
E888 / E816 Wiring
The E888 / E816 must be wired to the ACL via one of the ACL's two CAN
buses and should be powered from the vehicle battery.
Up to two E888 or E816 can be connected.
Note The second expander unit must be configured to a different CAN
address by MoTeC before it can be connected. This must be specified when
ordering the expander.
Refer to the E888 / E816 user manual for further details.
E888 / E816 Setup
There is no separate configuration program for the E888 / E816, all
configuration is done via ACL Manager.
ACL Setup
Inputs Setup
Using ACL Manager, select Inputs | Expander Inputs to assign inputs to
a channel and calibrate the inputs.
Inputs Communications Setup
Using ACL Manager, select Inputs | Communications to assign the
Expander Inputs template to one of the CAN sections.