MoTeC ACL VIM - Manual (Page 39)

MoTeC Installation & Configuration 35
ADL2 & SDL Firmware
ACL Manager will automatically update the firmware version in the device if
necessary, when sending the configuration to the ACL.
MDD Display
MDD Wiring
The MDD display must be wired to the ACL via one of the ACL's two CAN
buses and should be powered from the vehicle battery.
Refer to the MDD user manual for further details.
MDD Setup
The MDD setup requirements are the same as when the MDD is connected to
an ADL2. Refer to the MDD user manual for details.
All configuration is done using ACL Manager.
ACL Setup
Displayed Items Setup
Using ACL Manager, Select Functions | Display to use the Display
Setup screen to configure the displayed items.
Communications Setup
Using ACL Manager, select Inputs | Communications to assign the
desired MDD Transmit template to one of the CAN sections.
If not using CAN bus 0, click on the Advanced button to select the
correct CAN bus.
BR2 Beacon Receiver
BR2 Wiring
The BR2 beacon receiver must be wired to the ACL via one of the ACL's two
CAN buses and should be powered from the vehicle battery.
Note When using a BR2 with an ACL, it must be connected to the ACL via
CAN. The BR2 cannot be connected to a digital input on any of the other
connected devices.