MoTeC ACL VIM - Manual (Page 38)

34 Installation & Configuration
ADL2 & SDL Display
ADL2 & SDL Wiring
The display device must be wired to the ACL via one of the ACL's two CAN
buses and should be powered from the vehicle battery.
Refer to the ADL2 or SDL user manual for further details.
ADL2 & SDL Setup
All configuration is done using ACL Manager.
Important Do not use ADL2 Dash Manager or Sport Dash Manager software,
that is normally used to configure the display device.
ACL Setup
Inputs Setup
Using ACL Manager, select Inputs | ACL Connections, then in the
Connections screen, select Edit | Add to add one of the supported
display devices to the devices list and enter the device's serial number
and CAN bus number in the Connection Properties screen.
The various inputs can then be assigned to a channel and calibrated.
Refer to the Measurement Inputs section for more detail on sensors
and input types.
Outputs Setup
Using ACL Manager, select Functions | Auxiliary Outputs to configure
the Outputs in the setup screen.
Displayed Items Setup
Using ACL Manager, Select Functions | Display to use the Display
Setup screen to configure the displayed items.
Communications Setup
There is no need to configure the communications section of the ACL;
this is done automatically if the ADL2 or SDL is configured.