MoTeC ACL VIM - Manual (Page 40)

36 Installation & Configuration
Refer to the BR2 user manual for further details.
BR2 Setup
The BR2 beacon receiver has its own configuration program, however it is not
necessary to change the BR2 configuration when using it with an ACL.
Configuration of the BR2 is only required when using its switched output
function, which is not supported by the ACL, or if the BR2 switched output is
to be connected to another device such as an ECU.
ACL Setup
Inputs Setup
Using ACL Manager, select Calculations | Lap Time and Number to
configure the BR2 Mode and ID.
Communications Setup
Using ACL Manager, select Inputs | Communications to assign the BR2
template to one of the CAN sections.
If not using CAN bus 0, click on the Advanced button to select the
correct CAN bus.
SLM Shift Light Module
SLM Wiring
The SLM must be wired to the ACL via one of the ACL's two CAN buses and
should be powered from the vehicle battery.
Refer to the SLM drawing, available online at www.motec.com.au, for further
details.
SLM Setup
The SLM is configured using ACL Manager, which includes a specific setup
screen for the SLM.