Hach-Lange SIGMA SD900 Refrigerated Sampler and All Weather Refrigerated Sampler User Manual - Manual (Page 30)

28
Installation
3.3.3.1 Two or four bottle installation
Use 2 or 4 bottles to collect samples into 10-liter (2.5-gallon)
bottles. Bottle position numbers are molded on the pull out tray.
Prerequisites:
• Two or four 10-liter (2.5-gallon) plastic or glass bottles
• Positioner (refrigerated sampler only)
Installation procedure:
1. Clean the sample bottles as described in section 3.3.1 .
2. Insert the bottle positioner into the refrigerator compartment,
aligning the notch on the back left corner so that it clears the
drip tube (refrigerated sampler only).
3. For Refrigerated Samplers, place the bottles in the refrigerator
as shown in Figure 11 .
4. For All Weather Refrigerated Samplers, place the bottles in the
refrigerator as shown in Figure 12 .
5. Program the sampler.
Figure 11 Refrigerated two and four bottle installation
1 Removable tray (AWRS) (Cat. No. 5697600) 4 10-liter (2.5-gal) plastic or glass bottles (4x)
2 Positioner insert (refrigerated sampler) (Cat. No. 2038) 5 Front of sampler
3 10-liter (2.5-gal) plastic or glass bottles (2x)