Hach-Lange SIGMA SD900 Refrigerated Sampler and All Weather Refrigerated Sampler User Manual - Manual (Page 37)

35
Installation
3.4 Intake tubing and strainer installation
Place the intake tubing and strainer directly in the sample source to
collect samples. Refer to
section 3.2 on page 23 to make sure that
samples are free from contamination and are representative of the
sample source.
Prerequisites:
• Vinyl or Teflon-lined tubing
• Connection kit (Cat. No. 2186) (for Teflon-lined tubing only)
• Strainer
Note: See Accessories on page 94 for ordering information.
Installation procedure:
1. Connect one end of the tubing to the liquid sensor fitting.
Note: Use Cat. No. 2186 (connection kit) if using Teflon-lined tubing.
Figure 17 Distributor assembly installation
1 Refrigerated sampler 5 Thumbscrew
2 Sampler fitting 6 Arm stop
3 Retainer pins 7 Twist clip
4 Slots 8 All weather refrigerated sampler