Hach-Lange SIGMA SD900 Refrigerated Sampler and All Weather Refrigerated Sampler User Manual - Manual (Page 54)

52
Sampler operation
In addition, if a sonde is detected, current measurements can be
selected and viewed by the user.
4.7.2 Status for main program
The status screen for the main program gives information about the
program depending on the status of the main program. The status
information depends on whether the program is in the ready to
start, running/halted or complete mode.
4.7.2.1 Ready to start
The status reads READY when a program is ready to start and also
displays the power supply voltage and the current time.
4.7.2.2 Running/halted
The status reads RUNNING or HALTED when a program is currently
running or has been halted by the user. Use the RIGHT ARROW key
to access information about the program currently running.
The information displayed includes:
• Power supply voltage
• Inhibit mode (none, setpoint trigger, program delay, user
start, storm trigger, full bottle, setpoint delay)
• Sample summary (number of samples tried, missed and
remaining)
• Next sample information (sample number, bottle number of
next sample)
• Time before next sample
• Program start time
4.7.2.3 Complete
The status reads COMPLETE when a program ends after all sample
cycles have been completed or when ended by the user. Use the
RIGHT ARROW key to access information about the program that
just ended. The display includes:
• Power supply voltage
• Program end time
• Sample summary (number of samples tried and missed)