FEC AFC1500 - Manual (Page 10)

Never operate the equipment with wet hands
Failure to observe this instruction may cause electric shock.
Keep fingers away from the
is turned ON or for a while after the equipment is turned OFF.
hot. Failure to observe this instruction may cause burns.
Use the equipment under the following conditions.
◆ Ambient temperature: 0°C
◆ Ambient humidity: 90% RH or lower
◆ Atmosphere: Indoors (Avoid direct sunlight)
No corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
◆ Avoid direct vibration or shocks
Failure to observe this instruction may cause
Confirm and adjust all parameters before operation
of the equipment.
Failure to observe this instruction may cause injury,
Never conduct extreme adjustments or setting changes that may cau
Failure to observe this instruction may cause injury,
The equipment may restart suddenly
Always ensure that the start signal is OFF
Failure to observe this instruction
Do not turn the equipment ON and OFF repeatedly.
Failure to observe this instruction
Do not use the equipment at torque higher than
Failure to observe this instruction may shorten
high temperature caused by overload.
In case any abnormality occurs,
restarting the equipment.
Failure to observe this instruction may cause injury.
Safety Precautions
Operation / Adjustment
x
Never operate the equipment with wet hands or while standing in a wet location
this instruction may cause electric shock.
Keep fingers away from the AXIS (SAN) Unit radiating fin and tool motors while the equipment
is turned ON or for a while after the equipment is turned OFF. These parts may become very
this instruction may cause burns.
Use the equipment under the following conditions.
Ambient temperature: 0°C ～+45°C (Avoid freezing)
Ambient humidity: 90% RH or lower (Avoid moisture)
rs (Avoid direct sunlight)
corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
Avoid direct vibration or shocks
this instruction may cause earth leakage and malfunction.
ll parameters before operation in order to prevent unexpected movement
this instruction may cause injury, false operation and malfunction.
adjustments or setting changes that may cause instability of
this instruction may cause injury, false operation and malfunction.
The equipment may restart suddenly when the equipment is reset with the start signal ON.
Always ensure that the start signal is OFF before resetting the equipment.
instruction may cause injury.
Do not turn the equipment ON and OFF repeatedly.
instruction may cause malfunction.
equipment at torque higher than the maximum torque capacity.
Failure to observe this instruction may shorten equipment life or cause malfunction
high temperature caused by overload.
In case any abnormality occurs, remove the cause and ensure safety before resetting and
Failure to observe this instruction may cause injury.
Caution
Safety Precautions
/ Adjustment
or while standing in a wet location.
tool motors while the equipment
These parts may become very
in order to prevent unexpected movement
and malfunction.
se instability of operation.
and malfunction.
is reset with the start signal ON.
.
or cause malfunction due to the
remove the cause and ensure safety before resetting and
Caution