FEC AFC1500 - Manual (Page 107)

AFC1500 Multi-2 Unit Hardware Manual (Rev2.1)
PAGE 5 - 63
Chapter 5: Control Interfaces
Select the DATA TYPE format (BCD or ASCII).
Data from the Multi-2 and Axis (Spindle) must be configured in the table below each tab. The
MULTI FORMAT contains the “Header” data (such as Date, Time, Sequence #, Cycle Count, etc. –
aka data that comes from the Multi-2 Unit) The AXIS FORMAT contains the actual spindle
fastening data (such as Torque, Angle, Time, Rate, etc.) Right click on the table and select the item
that you wish to be transferred from the pop up window.
(Example of Multi format selection shown above)
Note: Selecting “Null” deletes the item from the list.
(Example of Axis format selection shown above – this format will be for EACH spindle connected in
the system)
When the system has more than 1 spindle, the data will be mapped as shown below.
Data from MULTI-2 controller
Data from SPINDLE 1 nutrunner
Data from SPINDLE 2 nutrunner
Data from SPINDLE 3 nutrunner
Data from SPINDLE 4 nutrunner
Data from SPINDLE 5 nutrunner….up to 31
spindles