FEC AFC1200 - Manual (Page 24)

)(& ,QF
7.1.11 VOCABULARY LIST 5 [REVERSE]
FIG. 7-1-11 set parameter [REVERSE]
NO. 1 REVERSE NUTrunner reverse speed during mode No. 1
NO. 2 REVERSE Nutrunner reverse speed during mode No. 2
NO. 3 REVERSE
NUTrunner reverse speed during mode No. 3
NO. 1 REVERSE
[SEC] -- Time (in seconds) for No. 1 Reverse mode
TIME [REV] -- Number of revolutions for No. 1 Reverse mode
NO. 2 REVERSE
[SEC] -- Time (in seconds) for No. 2 Reverse mode
TIME [REV] -- Number of revolutions for No. 2 Reverse mode
NO. 3 REVERSE [SEC] -- Time (in seconds) for No. 3 Reverse mode
TIME [REV] -- Number of revolutions for No. 3 Reverse mode
NOTE: EIther seconds [SEC] or revolutions [REV] may be set for No. 1~3, but not both.
REVERSE START Preset threshold torque for REVERse ANGLE COntrol
TORQUE
REVERSE ANGLE Preset angle value for REVERSE ANGLE CONtrol
REVERSE ANGLE HIGH High limit for REVERSE ANGLE
REVERSE ANGLE LOW
LOw limit for REVERSE ANGLE
REVERSE TORQUE HIGH
High torque limit for REVERSE ANGLE COntrol
Chapter 7: System Operation
Page 7-24