FEC AFC1200 User Manual
Page 70
)(& ,QF
7.9.7 header and line format - System Configuration Screens (1), (2) and (3)
7-1.
After selecting [SYSTEM CONFIGURATION] from the menu bar, move the cursor on
the menu bar to [PAGE UP] or [PAGE DOWN] and depress the
[↵]
key until the
screen displays [SYSTEM CONFIGURATION (1), (2) or (3)] as desired. DEpress the
[SEL] key. THe screen will change to the set mode with the first item (FASTENING
DATA PRINT OUT : YES/NO) highlighted.
7-2.
after configuring the basic preset values for [SYSTEM CONFIGURATION (1), (2) or
(3)], move the cursor down into the header format block using the
[↑]
[
↓
]
keys. the
[←][→]
keys are used to select the desired location within the header to be
configured. after the location has been selected, depressing the
[↵]
will cause the
[PRINT CHARACTER (DATA) INPUT] screen to appear.
7-3.
The [PRINT CHARACTER (DATA) INPUT] screen allows control characters,
alphanumeric and/or resultant data to be selected for use in the header setup. If
FREE FORMAT is chosen as the File Format in the Data File Utility screen (Section
7.13.0), then the data fields chosen on [SYSTEM CONFIGURATION (1)] screen will
be used in data collection and reporting.
The character selection is as follows:
00
→
1F
= CONTROL CHARACTERS
Standard control characters used in format are: 0A=LINE FEED, OC=FORM FEED,
OD=CARRIAGE RETURN. Other items are printer-dependent.
20
→
DD
= ALPHANUMERIC CHARACTERS
DE
→
FA
= FASTENING RESULT DATA
FB
→
FE
= RS232C CHANNEL 2 INPUT DATA
FF
= END OF PRINT (MUST BE USED AT END OF EACH LINE)
FIG. 7-9-7 header and line format for SYSTEM CONFIGURATION (1), (2) & (3)
7-4.
SElect the desired character/data from the displayed table by using the
[↑]
[
↓
]
and
[←]
[→]
keys. depress the
[↵]
key to paste the selected item into the selected
Chapter 7: System Operation
Page 7-70