FEC AFC1200 - Manual (Page 40)

)(& ,QF
The "accept" window always appears at
the far right of the screen, in accordance
with the High Angle value. High and low Angle limits
(25 ~ 10 degrees) and high
and low Torque (39 ~ 27 Nm) Accept window (seen in
the plot area of Fig. 7-4-4)
(Fastening Curve end)
Axis range displays highest reading as 25
Degrees. Overall range reflects as 200
(from -175 ~ +25) and is a product of
Angle Scale (200) x Divide(Angle) (1).
The overall range (200) divided by the
default number of tick marks (10) results
in 20-degree increments between tick
marks. Starting with 25 degrees at the
right side of the chart, the tick mark
values increment downward to -175. The
fastening Final Angle value (13.7) can be
read directly from the axis scale. High Angle limit: 25 Deg. (Set
Parameter), "200" Angle
Scale and "1" Divide(Angle) Horizontal "X" Axis Range
(Angle)
Axis range displays highest reading as
46.80 Nm (39 Nm high Torque x 1.2)
and the low defaults to zero (0). The
overall range (46.8) divided by the default
number of tick marks (8) results in 5.85
Nm increments between tick marks.
Starting with 46.8 Nm at the top of the
chart, the tick mark values increment
downward to zero (0). The plotted Torque
values can be read directly from the axis
scale. High Torque limit: 39 Nm
(setup in Set Parameter).
It is recommended to
manually setup this value with
the TORQUE SCALE
function. Vertical "Y" Axis Range
(Torque)
SETTING RESULTS SETTING SCREEN DISPLAY
FIG. 7-4-8 Fastening Curve
Chapter 7: System Operation
Page 7-40