FEC AFC1200 - Manual (Page 43)

)(& ,QF
3-3. USIng the
[←] [→]
keys, move the cursor to the "GP" (GROUP FASTENING)
heading. Enter the group number which corresponds with the spindle number
selected using the numerical keys (group numbers 01 thru 24 can be used). Depress
the
[↵]
key after selection and before
3-4. USINg the
[←] [→]
keys, move the cursor to the "PN" (PARAMETER NUMBER)
heading. Using the numerical keys, enter the fastening parameters to be used.
DEPRess the
[↵]
key after selection and before moving the cursor.
3-5. USing the
[←] [→]
keys, move the cursor to the "CA" (CAL CHECK) heading.
USING the
[±]
key, change the character to "X" for no CAL CHeck or to "O" if a CAL
CHeck is required. DEPress the
[↵]
key after selection and before moving the cursor.
3-6. USINg the
[←] [→]
keys, move the cursor to the "OF" (OFFSET CHECK) heading.
USINg the [
±
] key, change the character to "X" for no OFFSET Check or to "O" if an
OFFSET CHeck is required. DEPREss the
[↵]
3-7. USING the
[←] [→]
keys, move the cursor to the "OC" (OFFSET CORRECTION)
heading. USINg the [
±
] key, change the character to "X" for no OFFSET
CORRECtion or
"O" if OFFSET CORREction is required. DEPRESS the
[↵]
key after selection and
before
moving the cursor.
FIG. 7-5-3 set sequence, spindle setup
Chapter 7: System Operation
Page 7-43