Ransburg RMA-560 Single_Dual Purge Direct A13364 - Manual (Page 57)

Splash Plate Insertion (All Bell Cups)
Turn the splash plate removal tool over and use
the large diameter end to press the splash plate
back in place by hand. It may be necessary on
occasions to use an arbor press to install the
splash plate. Press splash plate to a hard stop
(see “Splash Plate Insertion” figure).
Splash Plate Insertion (30mm)
C A U T I O N !
† Failure to replace a damaged bell cup
will cause vibration of the applicator and/or
premature turbine failure.
Shroud Removal / Replacement
Removal
Remove five (5) screws from back of applicator.
Remove break-away ring and quick disconnect
ring. Pull shroud off.
Shroud Removal
A13559-00 SPLIT SHROUD ASSEMBLY
Replacement
Push the shroud back into place. A light tap on the
end may be required to seat the shroud in position.
Slide the quick disconnect ring over the shroud.
Reinstall break-away ring by aligning the four
(4) holes with the dowel pins on the recessed
face of the rear manifold. Reinstall the five (5)
stainless steel screws. Tighten evenly to 15-20
lbs•in (1.69-2.26 Nm) torque. If you are using the
optional plastic break-away screws, tighten evenly
to 5 lbs•in (.56 Nm) torque. The break-away rig
must lie flat against the face of the rear manifold.
C A U T I O N !
† DO NOT over-tighten the five (5) optional
plastic break-away screws or they may break
under normal operating conditions.
RMA-560 Single/Dual Purge Direct Charge - Maintenance
Ransburg
LN-9278-13 54