Ransburg RMA-560 Single_Dual Purge Direct A13364 - Manual (Page 63)

Valve Seat Torque
Lubricate the valve O-rings with a suitable O-ring
lubricant. By hand, start the threads clockwise
of the valve into the pocket. Tighten using a 1/2”
(13mm) socket and torque to 15-20 lbs•in (1.7-2.3
Nm) after valve is down.
Valve Torque
Support Rod Removal/Replacement
Removal
Using wrench (A11284-00 or A12061-00), remove
each of the support rods. Each is removed by
turning counter-clockwise.
Support Rod Removal C A U T I O N !
† Always use a torque wrench to torque the
seats in place. Over-torqueing the seats may
cause permanent irreparable damage to the
rear manifold.
Lubricate all the O-rings on the support tubes
with the appropriate lubricant. Install each until
the thread has bottomed out in the knuckle using
wrench (A11284-00 or A12061-00).
RMA-560 Single/Dual Purge Direct Charge - Maintenance
Ransburg
LN-9278-13 60