Ransburg RMA-560 Single_Dual Purge Direct A13364 - Manual (Page 78)

00 NONE NONE - - - -
01 A12090-01 76772-00, A12088-00, A11284-00, A11373-00, A11229-00,
A11388-00, A11922-00, 78279-00, A10766-00, LSCH0009-00
02 A12090-02 76772-00, A12088-00, A11373-00, A11229-00, A12061-00,
AA11388-00, A11292-00, 78279-00, A10766-00,
LSCH0009-00
TABLE H - TOOL KIT
Dash
No.
Tools Included “H”
TABLE J - REAR SHROUD
Dash No. Description “J”
Notes
01 A13444-00 ROUND SHROUD/LOGO
02 A13559-00 SPLIT SHROUD
FOR 55MM STANDARD BELL
CUP AND SHAPE AIR KITS
FOR 30MM AND 65MM BELL
CUPS AND SHAPE AIR KITS,
FOR 55MM BELL CUP WITH
55MM DUALFLEX SHAPE
AIR KIT
Fluid Coils (Separate Sales Parts Only)
If purchasing spare parts, they must be modified
as explained.
To ensure proper sealing and holding, the fittings
require that the ends of the fluid coils have a
groove cut into them as shown. Use groove cut-
ter A11567-00, by sliding the end of the tool over
the tubing until it bottoms out. Hold the tubing in
Fluid Coils
one hand and the tool in the other. Make three
complete revolutions of the tool on the tubing in
the direction of the arrow stamped on the tool. To
remove the tool, hold the tube and the main body
of the tool with one hand, slide the rear portion
of the tool back until it stops. Pull out the tubing
from the end of the tool. By pulling back the rear
portion of the tool, it relieves the pressure of the
cutting edge off of the tubing before sliding it out.
Trim off ends to dimensions shown. End should
be cut off square. Slide the fitting and ferrules
onto the tube as shown. The tapered ferrule must
go past the newly cut grooved to properly lock
into place when installed. Install hand tight and
then 1/4-1/2 turn more with a 9/16” end wrench
or flare nut wrench.
FITTING AND FERRULE
REPLACEMENT
78449-00
EMF-203-04
EMF-202-04
Part No. Description
FLUID FITTINGS
FRONT FERRULE
REAR FERRULE
RMA-560 Single/Dual Purge Direct Charge - Parts Identification
Ransburg
LN-9278-13 75