Ransburg RMA-560 Single_Dual Purge Direct A13364 - Manual (Page 85)

RMA-560 SINGLE/DUAL PURGE DIRECT CHARGE ASSEMBLY
Item Description Qty Part #
98 1 A13325-00 DIAPHRAGM
99 1 A13328-00 SCREW (M3 X 0.5 X 5 NYLON)
100 1 LSOR0005-18 O-RING, FEP ENCAPSULATED
101 1 A13542-00 FIBER OPTIC CABLE ASSEMBLY
105 1 “H” TOOL KIT (NOT SHOWN)
106 1 77141-26 LITERATURE KIT (NOT SHOWN)
Note 1: Lubricate all O-rings with Anojell (sparingly) to aid in installation.
Customer must verify spindle part number located on outer housing, see page 13
Torque bell cup assembly to a final torque reading of 50-70 lbs/in. (5.64-7.9Nm)
Torque fluid tip using A11229-00 tool to 25-30 lbs/in. (2.88-3.39 Nm)
Torque set screw in rear plate for fiber optic and low voltage connector to 5-10 lbs/in. (0.56-1.13 Nm)
Torque fluid tube into atomizer body using A11229-00 tool to 65/75 lbs/in. (7.34-8.47 Nm)
Tighten support tubes to a final torque of 10-15 lbs/in. (1.13-1.69 Nm)
Tighten air bolts to a final torque of 15 lbs/in. (1.69 Nm)
Tighten screws to a final torque of 15-20 lbs/in. (1.69-2.26 Nm) 10
6
8
2
5
9
7
1
RMA-560 Single/Dual Purge Direct Charge - Parts Identification
Ransburg
LN-9278-13 82