IAI America PDR-101-MW - Manual (Page 36)

26
4.8 Sensor (Optional) Input Connector
This is an input connector for LS (limit sensor), OT (over-travel sensor) and CREEP (creep sensor), which
are optional sensors that may be attached to the actuator.
List of actuator sensor input terminals (Phoenix MC1.5/6-G-3.5)
Symbol Function
24V Power supply for sensor, 24 VDC (+ side)
N Power supply for sensor, 24 VDC (- side)
LS Limit sensor
CREEP Creep sensor
OT Over-travel sensor
RSV Not used
z
24V and N are power-supply terminals dedicated for sensors and cannot be used for other purposes.
Do not connect cables other than the LS cable attached to the actuator to these terminals.
4.9 Regenerative Resistance Unit Connector
This is a connector for connecting a regenerative resistance unit (optional).
List of regenerative resistance unit connection terminals (Phoenix MC1.5/6-G-3.5)
Symbol Function
RB+ Regenerative resistance unit connection terminal (+ side)
RB- Regenerative resistance unit connection terminal (- side)
PE Regenerative resistance unit ground terminal
* The connector (plug) is attached to the regenerative resistance connection cable.
Caution