IAI America SEL-TG - Manual (Page 102)

7. Simple Operation Procedure
84
Select the F1 (Edit) key on the Mode Selection
screen.
Select the F2 (Prog) key on the Edit mode screen.
Select the F1 (Mdfy) key on the Edit-Prog (program
edit and new creation) screen.
The screen changes to the program No. input mode
screen. The cursor is located at the program No.
Press the return key to move the cursor to the
location of the step No.
 :KHQ WKH SURJUDP¶V GDWD LV DOUHDG\ LQSXW
overwrite it (the original data is lost) or select the
program No. with no data input. The program No. or
step No. over which the cursor is located can be
changed with the PAGE UP and PAGE DOWN keys.
,Q DGGLWLRQ SUHVVLQJ WKH UHWXUQ NH\ DIWHU LQSXWWLQJ D
numerical value with the 10 key can change the
program No. or step No.
$OVR \RX FDQ FKDQJH WKH SURJUDP 1R E\ SUHVVLQJ
the return key after the 10 key input. If the return key
LV SUHVVHG WKH FXUVRU will move to the step No.
7KHQ WKH SURJUDP 1R FDQ EH FKDQJHG ZLWK WKH
PAGE UP 䊶PAGE DOWN keys.
You can also input it directly by using the 10 keys.
Program No. Step No.
The number of steps saved in the
controller at the specific program.