IAI America SEL-TG - Manual (Page 81)

7. Simple Operation Procedure
63
Select the F1 key (Edit) at the mode selection
screen.
Select the F2 key (Prog) at the Edit Mode screen.
Select the F1 key (Mdfy) on the program edit and
new creation screen.
Change to the program No. input mode screen. The
cursor is located at the program No. Move the cursor
to the step No. with return key.
* If the program data is already input, write over
(the data will be gone) or select the program No.
which has no program data. The cursor location on
program No. or step No. can be changed with PAGE
UP · PAGE DOWN keys.
Also, you can change the program No. and step No.,
by pressing the return key after the 10 key input.
Program No. Step No.
The number of steps saved in the
controller at the specific program.