IAI America SEL-TG - Manual (Page 276)

258
*DWHZD\)XQFWLRQ
$VVRFLDWHG
258
&$87,21
,QWKHWHDFKLQJSHQGDQWWKHLQSXWUDQJHFKHFNLVQRWSHUIRUPHG
&RQ¿UPWKHVSHFL¿FDWLRQVIRUWKH5&DFWXDWRULQXVLQJDQGLQSXWWKHGDWD
In the case of the pressing operation, input the
Pressing Current Limit Value (%) and press
the key.
(The left figure shows the example where “0”
has been input).
* When the Pressing Current Limit Value is set to “0”,
the normal positioning operation is performed,
and it is set to “1” or more, the pressing operation is
performed.
Input the Positioning Completion Width (mm) and
press the key.
(The left figure shows the example where “0.10mm”
has been input).
Press the key and write the input position data
in the controller.
The input data is not written in the controller
until the key is pressed.
When the Axis No. or Position No. is changed
without pressing the key, the data before
the change is held.
CAUTION :
When the writing is completed, the screen is switched
to the display for the next Position No.