IAI America SEL-TG User Manual
Page 275
257
*DWHZD\)XQFWLRQ
$VVRFLDWHG
257
&$87,21
,QWKHWHDFKLQJSHQGDQWWKHLQSXWUDQJHFKHFNLVQRWSHUIRUPHG
&RQ¿UPWKHVSHFL¿FDWLRQVIRUWKH5&DFWXDWRULQXVLQJDQGLQSXWWKHGDWD
Axis No.
Position No.
Select the Axis No. and press the key.
* The selection of the Axis No. is performed using
the ten-key or key.
Select the Position No. and press the key.
* The selection of the Position No. is performed using
the ten-key or key.
Input the Target Position (mm) and press the key.
(The left figure shows the example where
“100.00mm” has been input).
* When the home return operation has been completed,
the current position can be taken in the target position
data using the key (Scan).
Input the Velocity (mm/sec) and press the key.
(The left figure shows the example where “50.00mm/sec”
has been input).
Input the Acceleration/Deceleration (G) and press
the key.
(The left figure shows the example where “0.30G” has
been input).
* The Acceleration and Deceleration can not be set
separately.