Spectra Precision ProFlex 800 Reference Manual User Manual
Page 146
132
Web Server Help Files Collection
network or through the Internet (network 1). See the
description of each parameter in the table below.
Direct IP via port E (Modem) or port P (Ethernet)
NTRIP Server via port E (Modem) or port P (Ethernet)
Parameter
Designation
$PASHS
Connection
Choose the type of network connection used in the
receiver:
• None: No network connection used.
• Modem Direct IP - Port E: The base is connected to
a remote server (possibly RTDS) via Internet using
its internal modem and a Direct IP connection.
• Modem NTRIP Server - port E: The base is con-
nected to the Internet via its internal modem using
an IP connection for sending its data to an NTRIP
caster. (The base is then a “client”.)
• Ethernet Direct IP - port P: The base is connected
to the Internet through its Ethernet port.
• Ethernet NTRIP Server - port P: The base is con-
nected to the Internet through its Ethernet port
using an IP connection to send its data to an NTRIP
caster. (The base is then a “client”.)
• Embedded NTRIP Caster - Port P: (Available only if
the NTRIP caster option is installed): The base
delivers its data to the embedded NTRIP caster via
port P.
MDM,..
NTR,PAR
DIP
Parameter
Designation
$PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-
Address
IP address of the remote server
DIP,PAR
Port
IP port number of the remote server
DIP,PAR
Login
(Optional, depending on the remote server) Login
required to connect to the remote server
DIP,PAR
Password
(Optional, depending on the remote server used)
Password required to connect to the remote server.
If a login and password are needed for the connection
to the server, then the receiver will send the $GPUID
command to the server after you have entered these
two parameters and clicked on the Configure button.
DIP,PAR
Parameter
Designation
$PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-