Spectra Precision ProFlex 800 Reference Manual - Manual (Page 613)

599
Query Command Library
Comments
• The response to this command will be sent out once, right
after the next PPS pulse is generated.
• The response contains the GPS time at which the PPS
pulse was sent, including the offset if an offset was set
when the PPS pulse was enabled.
• Being set to a periodical output by the $PASHS,NME,PTT
command, this message is independent of the NMEA
period. It is only linked to the PPS period.
PWR: Power Status
Function This command is used to query the power status of the
receiver.
Command Format Syntax
$PASHQ,PWR[*cc]
Response Format Syntax
$PASHR,PWR,PAR,f1,f2,d3,[f4],[d5],[f6],[d7],d8[,f9,f10]*cc