GW Instek GDS-200 Series Programming Manual - Manual (Page 74)

GDS-200 & GDS-300 Programming Manual
74
:MEASure:PEDGE
Description Returns the number of positive edges.
Syntax :MEASure:PEDGE?
Related
Commands :MEASure:SOURce<X>
Return parameter <NR3> Returns the number of positive edges.
Chan Off Indicates the source channel is not
activated.
Note Before using this command, select the
measurement channel. See the example below.
Example :MEASure:SOURce1 CH1
:MEASure:PEDGE?
1.100E+01
Selects Channel 1, and then measures the number
of positive edges.
:MEASure:NEDGE
Description Returns the number of negative edges.
Syntax :MEASure:NEDGE?
Related
Commands :MEASure:SOURce<X>
Return parameter <NR3> Returns the number of negative edges.
Chan Off Indicates the source channel is not
activated.
Query
Query