Jenway Genova Nano German - Manual (Page 27)

SECTION 6 – Concentration
The concentration measurement mode enables simple measurements of absorbance and concentration
to be performed. In this measurement mode it is possible to calibrate against a standard of a known
concentration or use a known factor. The sample is measured at one wavelength at one point in time.
There are no post measurement calculations available in this measurement mode.
6.1 MODE SPECIFIC PARAMETERS
The concentration operating menu enables measurement
parameters to be changed. The utility toolbar on the left
hand side of the screen enables access to printing, print
setup options, results, methods and autologging options.
For more details on the different functions of the utility
toolbar refer to section 17. The settings icon enables the
wavelength, units, resolution, standard or factor to be
set.
Fig 6.1.1 - Operating Menu
6.2 METHOD SETUP
6.2.1 Selecting a Wavelength
The wavelength can be adjusted in the operating menu
or in the settings menu. To adjust the wavelength, in the
operating menu, use the keys adjacent to the arrow icons
to increase or decrease the wavelength.
The settings menu is accessed through the operating menu
by pressing the key adjacent to the settings icon. In the
settings menu press the key below the wavelength icon.
Operating Menu
Print/print settings
Results selection menu
Method selection menu
Autolog menu
Calibrate to zero
or standard
Measure to
factor
Settings
Increase wavelength
Decrease wavelength
25