Jenway Genova Nano German - Manual (Page 88)

Once the number of repetitions is increased above zero,
if the results are autologged to a USB memory stick, the
batch ABC icon will be displayed. To assign a batch name
for the repeated measurements press the key below the
batch ABC icon to open the batch naming menu.
The default batch name will be displayed. To save the
batch name under the default name press the key adjacent
to the tick icon. To change the name, press the key below
the eraser icon. One press of the key will delete one
letter, holding the key for 2 seconds will delete the name
completely. To select letters use the keys adjacent to the
arrow icons to move around the menu. Once the required
letter is highlighted press the key below the pencil icon to
select the letter. Up to eight characters can be selected. To use numbers in the batch name press the key
below the AB icon. Repeat pressing of this key will cycle between upper case and numbers. Once the
required name for the batch has been entered press the key adjacent to the tick icon to save and return
to the autolog menu.
To set the time period between each measurement press
the key below the timer icon and use the keys adjacent
to the arrow icons to increase or decrease the time in 1
second intervals. To reset the time to one second press and
hold the key below the timer icon for 2 seconds.
Once the required number of repetitions and time period has been selected press the key adjacent to the
tick icon to save the changes and return to the operating menu.
The number of repetitions and time period will be displayed
below the autolog icon. To commence autologging press
the key below the measure sample icon. Once the first
measurement has been performed the time period starts
counting down until it reaches zero and then the next
measurement will be taken. This will reduce the repetition
number by one. When the number of repetitions reaches
zero autologging is complete. Autologging can be stopped
before all the measurements have been completed by pressing the key adjacent to the autolog icon.
Confirmation will be needed to stop autologging. Press the key adjacent to the tick icon to confirm
stopping autologging or press the key adjacent to the cross icon to continue autologging. If autologging
is stopped before completion the measurements already recorded will be saved under the previously
entered batch name.
Once a set of results has been autologged to the USB
memory stick when the measure sample key is pressed
again the batch append/delete screen is displayed. Pressing
the key adjacent to the batch append icon enables the
next set of results to be added to the existing batch of
results. Pressing the key adjacent to the batch delete icon
will delete the first set of results and replace them with
86