Jenway Genova Nano German - Manual (Page 57)

11.2.2 Concentration Plus Settings
The concentration plus settings menu enables the wavelength, units, resolution, standard, factor and
dilution factor to be set and is accessed from the operating menu by pressing the key adjacent to the
settings icon. Once all of the required settings have been entered press the key adjacent to the tick icon
to save and return to the operating menu.
Fig 11.2.2.1 – Settings Menu
When setting the method parameters either the standard value or a factor should be entered. The
standard should be used if the factor is not known as selecting this option will calculate the factor. If the
factor is known it is not necessary to measure a known standard’s concentration. When the standard or
factor is not being used the value should be set to 1.00.
11.2.2.1 Selecting a Wavelength – Concentration Plus Settings
The wavelength can be adjusted in the settings menu by
pressing the key below the wavelength icon. This will open
a number entry screen.
Use the keys at the bottom of the screen to select the digit
to be adjusted. The key below the digits must be pressed
twice to select the adjacent digit. Use the keys adjacent to
the arrow icons to increase or decrease the wavelength to
the required number. Press the key adjacent to the tick icon
to save the changes and return to the settings menu.
11.2.2.2 Selecting Concentration Units
The units of concentration can be selected from a number of options: no units, %, ppm, EBC, SRM,
mEq/l, mEq, M, mM, µM, nM, U, U/l, U/ml, g/l, mg/l, µg/l, ng/l, g/dl, mg/dl, µg/dl, mg/ml, µg/ml, ng/ml,
µg/µl, ng/µl, mol/l, mmol/l.
Setting the
dilution factor
Tick icon
Standard menu
Factor menu
Selecting
resolution
Selecting a
wavelength
Selecting concentration
units
55