Badger Meter M-Series M4000 - Manual (Page 16)

16
8. Attach the chamber cover.
AMPLIFIER CONTROLS, CONTROL METHODS and DATA
DISPLAY PROGRAMMING
The M-4000 amplifi er display/programming chamber
contains a display/control card. This card and its display
screen provide easy access to meter information and the
ability to view, program and adjust meter data parameters.
Card Display and Controls
The M-4000 uses a 2.5 X 1 inch (63 X 25mm) four line,
16-character, backlit, LCD display.
Display screens and screen data are manipulated with
magnet switches or push buttons. By operating the switches
or buttons different screens are accessed, program
parameters are selected and changed and settings are
reprogrammed.
If no contact is made with switches or buttons for 2 minutes,
in any parameter, the display returns automatically to the
Main Screen.
ACCESS to AMPIFIER SCREENS, DATA and
PARAMETER PROGRAMMING
NOTE: The M-4000 can be programmed to meter many
fl ow situations and serve a variety of purposes during a
production process. To meet diverse needs there are a
wide variety of programming options and parameters. Your
metering requirements probably do not require the use of all
program screens, options and parameters.
Your M-4000 amplifi er is delivered preprogrammed, based
on information available at the time the unit was ordered. In
most instances it will not require any changes.
Use this section to program fl ow signal outputs or reprogram
your meter to specifi c requirements.
Flow measurement and totalizing continues during amplifi er
programming.
Two Programming Methods
There are two methods for programming.
In one method a magnet wand is used to manipulate +, -
and E switches to view and change screens and program
functions and settings. The amplifi er display chamber cover
stays on.
The other method involves removing the display chamber
cover and manipulating the +, - and E push buttons to view
and change settings and program desired meter functions
and settings.
AMPLIFIER SCREENS, MENUS and PROGRAMMING
Amplifi er programming requires planning, moving and
activating the +, - and E selections on three types of menu/
parameter screens, List screen, Input Numbers screen and
select ON or Off screen.
MAIN SCREEN(S)
The fi rst screen is the Main Screen. It is always displayed
when programming functions are not occurring.
NOTE: When programming, if no contact is made with
switches or buttons for 2 minutes, in any parameter, the
display returns automatically to your programmed Main
Screen.