Badger Meter M-Series M4000 - Manual (Page 33)

33
In the Flow Chart:
1. Each separate screen is inside a box.
2. If a screen “branches”, an arrow points right and each screen of the branch is in a box.
3. When there is text, but it’s not in a box, that signifi es a parameter setting and a short explanation is given of the parameter.
Mark on the chart what parameters need to be set. Note parameter settings on the chart. Program your amplifi er accordingly.
Keep the chart as a reference for other shifts and personnel and to monitor meter performance.
FLOW CHART _ MENU STRUCTURE
Menu Structure
Meter Setup Pipe Dia.
Enter the flow tube diameter
Detect Factor Enter the meter calibration factor
Excitation Freq Select the coil excitation frequency
Calibration Electric Zero
All calibration factors
Elec Full Scale are determined at the
Hydr. Zero-Man factory.
Hydr. Zero-Auto
Empty Pipe Cal. empty pipe
Empty pipe detection setup.
Cal. full pipe
Enable/Disable
Chg. Password Password new
Enter 0000 to disable password.
Measurements Rate Unit Select flow rate unit
Totalizer Unit Select total volume unit
FullScaleFlow Enter full scale flow for the analog output.
LowFlowCutOff
Enter the low flow cut off. Typically 0.2%.
Flow Dir. Select uni-directional or bi-directional flow.
Damping Factor Select as needed.