Badger Meter M-Series M4000 - Manual (Page 23)

23
2. At LowFlowCutOff 24 screen input a percentage at the
arrow. Press E.
Set Flow Direction
1. At MEASUREMENTS 20 press + fi ve times to set the
arrow at Flow Dir. Press E.
2. At FLOW DIR 25 press + or - to select Uni-Directional or
Bi-Directional.
3. This type of screen shows for 2 seconds.
Set Damping Factor
1. At MEASUREMENTS 20 press + six times to move the
arrow to Damping Factor. Press E.
2. At DampingFactor 26 press Exit this Menu, No Damping
or press a Time Frame.
3. If No Damping is selected, this type of screen shows for
2 seconds.
4. And this type of screen shows for 2 seconds when
Damping Factor time is selected.
5. MEASUREMENTS 20 screen returns with the arrow
pointing at Exit this Menu.
6. Press E once to place cursor at Main Menu 00.
7. Press E once to move cursor back to the Main Screen.
Empty Pipe Calibration
1. Press E once to move to Main Menu.
2. In the MAIN MENU 00, select to Meter Setup.
3. In METER SETUP 10, select Empty Pipe.