HP Hitachi Dynamic Link Manager Software - Manual (Page 165)

3. Creating an HDLM Environment
143
• Building a new pre-migration environment:
Perform the procedure described in (4) Migration by Building a New
Pre-Migration Environment in 3.6.2 Procedure for Configuring a Boot Disk
Environment, and then execute the procedure described in (5) Setting Up the
Post-Migration Environment in 3.6.2 Procedure for Configuring a Boot Disk
Environment.
3.6.2 Procedure for Configuring a Boot Disk Environment
The command examples and setting examples in this section assume the following
slice allocations:
• Slice 0:
/
(
root
) file system
• Slice 1: Swap device and dump device
• Slice 3: Sun Cluster global device file system
• Slice 6:
/usr
file system
• Slice 7: Replica of the SDS or SVM state database
For details on procedures involving Solaris functionality, see your Solaris
documentation.
(1) Migration from an Existing HDLM Environment
Perform the steps below in the pre-migration environment. The workflow is shown in
Figure 3-8: Flow of setting up the boot disk environment when using an existing
HDLM environment as the pre-migration environment.