HP Hitachi Dynamic Link Manager Software - Manual (Page 178)

3. Creating an HDLM Environment
156
specified for the boot device.
12. Boot the system from the post-migration environment.
• Perform steps 13 to 17 only if SDS or SVM is being used and you are
migrating a replica of the SDS or SVM state database to the post-migration
environment. In this case, keep the pre-migration environment recognized by
Solaris.
• Skip to step 18 if SDS or SVM is being used but you are not migrating a
replica of the SDS or SVM state database to the post-migration environment.
• Skip to step 18 if SDS or SVM is not being used.
13. Check the state database settings.
An example is shown below.
14. Add the post-migration boot disk to the SDS or SVM state databse.
An example is shown below.
# metadb -a /dev/dsk/c8t50060E80004361D1d1s7
# metadb -a /dev/dsk/c8t50060E80004361D1d2s7
# metadb -a /dev/dsk/c8t50060E80004361D1d3s7
15. Make sure that the post-migration boot disk has been added to the SDS or SVM
state database.
An example is shown below.
16. Delete the SDS or SVM state database replica that exists in the pre-migration boot
disk.