HP Hitachi Dynamic Link Manager Software - Manual (Page 361)

4. HDLM Operation
339
Figure 4-18: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file (after
editing)
The shaded portion indicates the text to be edited.
Note
Do not make any modifications other than adding or deleting the hash mark
(#) in front of the
LDEV
property line corresponding to the LU.
6. Apply the settings in the HDLM driver unconfiguration definition file (
/opt/
DynamicLinkManager/config/dlmfdrv.unconf
) to the HDLM driver
configuration definition file (
/kernel/drv/dlmfdrv.conf
):
Execute the following command:
# /opt/DynamicLinkManager/bin/dlmsetconf -u
7. Execute the
dlmcfgmgr
utility shown below to make the HDLM driver recognize
the LU to be managed by HDLM:
# /opt/DynamicLinkManager/bin/dlmcfgmgr -a
8. Check the status of the path accessing the LU to be managed by HDLM.
The following shows an example of executing the command. The shaded portion
is the path to access the LU to be managed by HDLM.