HP Hitachi Dynamic Link Manager Software - Manual (Page 490)

7. Utility Reference
468
7.8 The installhdlm Utility for Installing HDLM
You can use the
installhdlm
utility to perform a new installation, upgrade
installation, or re-installation of HDLM in unattended installation mode. You must
predefine how the utility is to respond during installation in the
installation-information settings file.
For details on the procedure for performing an unattended installation, see
3.5.3 Performing a New Installation of HDLM (When Sun Cluster Is Not Being Used),
3.5.4 Performing a New Installation of HDLM (When Sun Cluster Is Being Used), or
3.5.7 Performing an Upgrade Installation or Re-installation of HDLM.
7.8.1 Format
/
directory-where-DVD-ROM-is-mounted
/hdlmtool/instutil/installhdlm {
-f
installation-information-settings-file-name
| -h}
7.8.2 Parameters
-f
installation-settings-file-name
Defines the information required to perform an installation.
For details on the installation-information settings file, see 7.8.3 Contents of the
Installation-Information Settings File.
-h
Displays help about the usage of the command.
7.8.3 Contents of the Installation-Information Settings File
The following describes the contents of the installation-information settings file.
[INSTALLATION_SETTINGS]
section
This section defines operation information for the
installhdlm
utility. The
[INSTALLATION_SETTINGS]
section must be specified first in the
installation-information settings file. However, this section may be preceded by a
blank line or comment line.
Table 7-4: Keys that Can Be Defined in the [INSTALLATION_SETTINGS] Section
describes the keys that can be defined in the
[INSTALLATION_SETTINGS]
section.