HP Hitachi Dynamic Link Manager Software - Manual (Page 351)

4. HDLM Operation
329
Execute the following command to clear the install mode of a cluster when it
consists of two nodes:
# /usr/cluster/bin/scconf -c -q reset
17. Perform registration for the disk device group, create the file system, or set up the
global mount as necessary.
For details, refer to the Sun Cluster documentation.
(2) Changing a Non-HDLM-Managed Device to an HDLM-Managed Device (When
the Node Must Be Restarted)
Note
On all nodes in the cluster, have HDLM driver recognize the LUs to be managed,
and make the configuration the same on each node.
To change a non-HDLM-managed device to an HDLM-managed device (when the
node needs to be restarted):
1.
Log in to Solaris as a user with root permissions.
2. Check the LU to be managed by HDLM.
You can check the LU by using the
format
command. Figure 4-13: Example
of executing the format command shows an example of executing the
format
command. The shaded portion represents the LU to be managed by HDLM.
Figure 4-13: Example of executing the format command