HP Hitachi Dynamic Link Manager Software - Manual (Page 335)

4. HDLM Operation
313
The KAPL10242-I message appears when you execute the
dlmsetconf
utility.
Type
y
in response.
15. Execute the following command to compare the HDLM driver unconfiguration
definition file before and after execution of the
dlmsetconf
utility:
# diff dlmfdrv.unconfbak
n
dlmfdrv.unconf
Compare the old and new files to make sure that the reconfigured environment is
recognized by HDLM. An example is shown below.
Execution example after an HBA is replaced:
Check that all paths for the same type of HBA device have been deleted from
the shaded portion, and that a path indicating the same type of HBA device
has been added in the part after the shaded portion.
Execution example after a path is added by the addition of an HBA port:
Check that a path for the same HBA port has been added:
36a41,44
> ### Device=ssd74 target=65664 lun=2